PROBLEM CAUSE CORRECTION
"Sb"is * The control is in ", Pressing the CONTROL LOCK and TEMP
displayed on Sabbath Mode. MODE keys to exit Sabbath Mode,
control. "
SOUND AND NOISE
Louder 0 Appliance operates at higher ' o This is normal. Sound will level off or
sound levels pressures during the start of disappear as appliance continues to run.
whenever the ON cycle. I
appliance is '
on, "
Popping or * Metal parts undergo * This is normal. Sound will level off or
cracking expansion and contraction, as disappear as appliance continues to run.
sound when in hot water pipes.
compressor • Refrigerant (used to cool • This is normal.
comes on,
Bubbling or refrigerator) is circulating
gurgling throughout the system.
sound.
Vibrating or ' Appliance is not level: It rocks , Level the appliance, Refer to
rattling noise, onthe floor when it !s m0ved '_LeveHng" section.
s.ght y.
Foor is! Uneven 9i wea!, aE;_ re flo_[¢e_ _deq; _lysu pp _
wood or meta shims under part ofthe
Appliance iS t0uching I Re.level appliance or move appliance
the wall: I slightly. Refer to "Leveling'! in the
• • INSTALLATION section.
WATER / MOISTURE / FROST INSIDE APPLIANCE
Moisture' Weather is hot and humid, , This is normak
forms on which increases internal rate
inside of frost buildupl
aPal_lis?rice ' D0oiis Slightly Openl' see,_DOOR PROBLEMS";
• Door is kept open too long. • Open the door less often:
ODOR IN APPLIANCE
Odors in ' Interior needs to be cleaned. ' Clean interior with Sponge, warm water, and
appliance I bakngsoda Repacearfiter! I
- Foods with strong odors are - Cover the food Lightly.
in the appliance.
DOOR PROBLEHS
Door will , Appliance is not !evel: It * This condition can force the cabinet out
not close, rocks on the floor when it is of square and misa!ign the door. Refer to
moved s!ightly, "Leveling" section:
o Foor s uneven or weak. , Ensure floor can adequatey support app ance.
Level the appliance by putting woo d or metal
shims under part of the app lance.
LIGHTING PROBLEHS
Light bulb is ' The light bu!b is burned OUt, * Follow directions under INTERIOR
noton I I LIGHTING secton
NO electric current is reaching See !!Appliance does not run':
the appliance.
I ' Control is in Sabbath mode , Depress TENP NODE key and CONTROL
• (Sb is displayed on control). LOCK key for 3 seconds.
To Next Page
Loading...
