TO BE REMOVED BY THE CUSTOMER AFTER INSTALLATION IS COMPLETE. (TurntoothersideforSpanishversion,)
f
[] INSTALLATION CHECKOFF LIST
_oors
[] Handies are secure and tight
[] Door seais compieteiy to cabinet on ali sides
[] Doors are ievei across the top
Leveling
[] Refrigerator is ievei, side to side and tilted 1/4" (6mm) front to back
[] Toe grHie is properiy attached to refrigerator
[] Cabinet is setting solid on ali corners
[]
[]
ElectricaJ Power
House power turned on
ice Maker
[] House water suppiy connected to refrigerator
[] Water & power couplings connected at door
[] No water ieaks present at ali connections - recheck in 24 hours
[] ice Maker is turned ON,
[] ice & Water Dispenser operates correctiy
[] Front fiiter must be flush with fiiter housing (some modeis)
FinaJ Checks
[] Shipping material removed
[] Fresh Food and Freezer controls set
[] Crisper Humidity controis set
[] Registration Card sent in
SHIPPING MATERIAL
HAND TRUCKING
* Load refrigerator from side of cabinet
only,
. Do not run retaining straps over
handies,
Do not over4ighten retaining straps,
o Never use refrigerator handies to
move the refrigerator,
Remove tape from doors only after
unit is in @ace,
INSTALLATION CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
Sides & Top.......... 3/8"
Back ....................... 1"
NOTE: if you are installing your refrigerator beside a wall,
leave 1/2" minimum between hinges and waHHto aHHowfor
the door to swing open.
! PIECE OF TAPE --
WIRE TreES and/or TAPE_
(On all wire baskets)
_666686
}
_ce Water
Ensureicemakeris turnedON.Togain access to the icemaker,
slide the ice cream tray out. Check to see that the ice & Water
Dispenser is operating correctB,.(See Automatic ice & Water
Dispenser Featuresin Use & CareManua!.)
J
=1 !1_ --
--t PIECE OF TAPE OR
2 BLUE SHIPPING CLIPS
--SHELF SPACER WroTH TOE GRmLLE
--1 PIECE OF TAPE
--3 PIECES OF TAPE
PIECE OF TAPE
PIECES OF "rAPE
--3 PIECES OF "rAPE
.. Remove Shipping material (Features may vary per model.) ._
f
LEVELING AND ADJUSTING
AiMfour corners of refrigerator must rest firmly on a sow
floor, Your refrigerator has adjustable rollers to hemplevel it
and to adjust the doors,
To teveJcabinet or change door height:
1, Remove toe grille,
2, Use a screwdriver, 3/8"wrench, or nutdriver to adjust the
rollers,Toraisecabinet or door, turn screw clockwise,To
Mowercabinet or door, turn screw countercHockwise,
Cab'ir_etr _°_*
Tools You Will Need:
When
changing
controm
settings, wait
24 hours before
making additional
adjustments.
TO CONNECT
if you need to remove the doors to get your refrigerator in the house, @ease see
Door Removal/RstructioRs in your Use & Care Manual.
J
x' See"Norma_ Operating Sights & Sounds" in the Use & Care
Manualso you understand the sounds you may hear once
your refrigerator is running,
_ Ptease read entire Use & Care ManuMto become aware of
important safety instructions and to become familiar with your
new refrigerator,
x_ Send in Registration card to register your refrigerator,
x_ Congratulations! You are ready to enjoy your new refrigerator,
IFYOU ARE DISSATISFIED WITH THE INSTALLATION OFYOUR REFRIGERATOR, PLEASE CALLTHE STORE YOU PURCHASED IT FROM. P/N:241540501
To Next Page
Need help?
General
