Fritz! FRITZ!WLAN 310 - Button and LEDs; Button; LEDs

FRITZ!WLAN Repeater 310 Installation and Operation Instructions
2
Button and LEDs
The Fritz!WLAN Repeater has a button and various LEDs on the front panel.
Button
The Following functions are operated using the button:
Function Press for at Least
Switch wireless LAN on and off 1 second
Initiate WPS quick connection 6 seconds
Reset the repeater to factory settings 15 seconds
LEDs
LED Condition Meaning
Flashing No connection with WLAN base station or searching for WLAN base station
Up to 5 LEDs
are lit up
The more LEDs are lit up, the stronger the signal of the WLAN radio
connection between the WLAN base station and the Fritz!WLAN Repeater.
Power
Flashing
• Fritz!WLAN Repeater starts
• Updating the firmware of the Fritz!WLAN Repeater
On Fritz!WLAN Repeater is ready for operation
WLAN
Flashing
• Fritz!WLAN Repeater adopts WLAN settings
• Switching WLAN radio network on or off
• Performing WPS
Flashing
rapidly
WPS procedure was aborted: More than two WLAN devices are performing
WPS at the same time. Repeat the procedure.
On The WLAN module of the Fritz!WLAN Repeater is ready for operation
All Flashing Factory setting are loaded