Fronius BIAS 300 Plasma - Page 60

No.: 1
Programming error
Contact After-Sales Service
Cause:
Remedy:
No.: 2, 3 and 4
Overtemperature in power source secondary circuit
Allow the power source to cool down
Cause:
Remedy:
No.: 5, 6, 7, 8, 9 and 10
Overtemperature in power source primary circuit
Allow the power source to cool down
Cause:
Remedy:
No.: 11
Temperature sensor 1 fault
Contact After-Sales Service
Cause:
Remedy:
No.: 12
Temperature sensor 2 fault
Contact After-Sales Service
Cause:
Remedy:
No.: 13
Temperature sensor 3 fault
Contact After-Sales Service
Cause:
Remedy:
No.: 14
Temperature sensor 4 fault
Contact After-Sales Service
Cause:
Remedy:
No.: 15
Temperature sensor 5 fault
Contact After-Sales Service
Cause:
Remedy:
No.: 16
Temperature sensor 6 fault
Contact After-Sales Service
Cause:
Remedy:
No.: 17, 18, 19, 20 and 21
DSP fault
Contact After-Sales Service
Cause:
Remedy:
No.: 22, 23, 24, 25, 26 and 27
HOST fault
Contact After-Sales Service
Cause:
Remedy:
No.: 29
DSP fault
Contact After-Sales Service
Cause:
Remedy:
No.: 31 and 32
HOST fault
Contact After-Sales Service
Cause:
Remedy:
No.: 33
Overtemperature in the power source control circuit
Allow the power source to cool down
Cause:
Remedy:
60