Fronius BIAS 300 Plasma - Page 61

No.: 34
Temperature sensor 7 fault
Contact After-Sales Service
Cause:
Remedy:
No.: 35 and 36
DSP fault
Contact After-Sales Service
Cause:
Remedy:
No.: 37
HOST fault
Contact After-Sales Service
Cause:
Remedy:
No.: 38
Robot not ready
Set „Robot ready“ and „Source error reset“ signals
Cause:
Remedy:
No.: 49
Phase failure
Check the mains fuse, the mains supply lead and the mains plug
Cause:
Remedy:
No.: 50
Intermediate circuit balance error
Contact After-Sales Service
Cause:
Remedy:
No.: 51
Mains undervoltage: mains voltage has fallen below lower limit of to-
lerance range (+/- 15%)
Check the mains voltage
Cause:
Remedy:
No.: 52
Mains overvoltage: mains voltage has exceeded the upper limit of the
tolerance range (+/- 15%)
Check the mains voltage
Cause:
Remedy:
No.: 53
Ground (earth) fault
Remove ground (earth) fault
Cause:
Remedy:
No.: 75
MM_ARC PCB fault
Contact After-Sales Service
Cause:
Remedy:
No.: 100, 101, 102, 103, 104, 105, 106, 107, 108 and 109
HOST fault
Contact After-Sales Service
Cause:
Remedy:
No.: 150
Power source switched off or no mains voltage
Switch on power source or check mains voltage
Cause:
Remedy:
61
EN