119
EN-US
IMPORTANT! A good seal is achieved only
by adhering to the following procedures a)–
b) which ensure the sealing foam is correc-
tly positioned.
Suspend the power module cover on
the mounting pins above, pull the pow-
er module cover downwards in a more
inclined position a) and swing it under
tension onto the base shell b).
IMPORTANT! When closing the cover,
make sure that the springs on the keys en-
gage in the guides.
Then fasten the power module cover
(3) with 4 x 5x18 mm TX25 screws (2)
with a sealing washer
Tightening torque = 2.5 Nm
Installation
Mount the inverter on the wall bracket
at a maximum angle of 11° and press it
down towards the wall bracket
a)
b)
2
(2) (2) (2)(2)(3)
NOTE! If the screw threads slip
and will no longer grip, use the fol-
lowing screws:
PT 5x25 mm T25 KT25
(Item number 42,0401,4231)
3
4.33 in.
110 mm
max. 11°
4
To Next Page
Loading...
