General
Quick-fastener
system
A quick-fastener system (3) is used to
mount the connection area cover and
front cover. The system is opened and
closed with a half-rotation (180°) of
the captive screw (1) into the quick-
fastener spring (2).
The system is independent of torque.
NOTE!
Danger when using a drill driver.
This may result in the destruction of the quick-fastener system due to over-
torque.
▶
Use a screwdriver (TX20).
▶
Do not turn the screws more than 180°.
Warning notices
on the device
Warning notices and safety symbols are located on the inverter. These warning
notices and safety symbols must not be removed or painted over. They warn
against incorrect operation, as this may result in serious injury and property dam-
age.
Symbols on the rating plate:
Devices marked with the CSA certification mark satisfy the require-
ments of the relevant product standards for Canada and the USA.
35
To Next Page
Loading...
