The network wizard and product setup can be performed independently. A net-
work connection is required for the Solar.web installation wizard.
Ethernet:
1
open access point
192.168.250.180
2
1
Establish a connection to the inverter (LAN1) using a network cable (min.
CAT5 STP).
2
Open the access point by touching the sensor once
ü
Communications LED flashes blue.
3
Enter the IP address 169.254.0.180 in the address bar of the browser and
confirm. The installation wizard opens.
4
Follow the installation wizard and complete the installation in the individual
areas.
5
Add the system components in Solar.web and commission the PV system.
The network wizard and product setup can be performed independently. A net-
work connection is required for the Solar.web installation wizard.
69
To Next Page
Loading...
