Fronius Robacta PTW 500 - Robacta PTW Model Options and Accessories; PTW 500 Optional Accessories; PTW 1500 Optional Accessories; PTW 3500 Optional Accessories

Assembling the
Robacta PTW
1500
1
2
3
4
Fit holder, insert clamping sleeve
1
2
1
Insert tungsten electrode
2
IMPORTANT! Insert the tungsten electrode so that the tip protrudes approx. 10
mm out of the torch body. Slightly tighten the torch cap so that the tungsten
electrode can still move inside the torch body.
10 mm
max. 3 Nm
2
3
1
Assemble centring tube, plasma nozzle and
shielding gas nozzle
3
IMPORTANT! Check that the tungsten
electrode is adjusted correctly (see
„Adjusting the tungsten electrode“)
29
EN