Fronius THP 120 - 300 SH - Replacing the User Interface; Replacing the Slide

Replacing the
user interface
(1)
(2)
Removal
1
Unscrew one TX 8 screw (1)
2
Disconnect the user interface (2)
Installation
1
Connect the user interface (2)
2
Secure one TX 8 screw (1)
Tightening torque: 0.6 Nm
Replacing the
slide
(1)
(2)
1
Remove the user interface as per the
"Replacing the user interface" chapter
2
Position a suitable tool on the plastic
guide on the slide (1) and carefully
push it in the direction of the arrow
using slight pressure
3
Remove the slide (2) from the guide
(2)
(2)
4
Insert the new slide (2) into the guide
until it engages
5
Install the user interface as per the
"Replacing the user interface" chapter
14