4
1
3
2
5
Fronius International GmbH, www.fronius.com
Quick Reference: English
Setting the welding power
Selecting the ller metal and
shielding gas
2 T 2-step mode
4 T 4-step mode
S 4 T Special 4-step mode
Selecting the process
Setting the mode
MANUAL MIG/MAG standard manual
SYNERGIC Standard synergic
STICK Manual metal arc welding
Correcting parameters
Important If external system components
are connected, some parameters can be
modifi ed on those components. The power
source control panel is only for display
purposes.
01/2011
Text and illustrations were accurate at the time of printing. We reserve the right to make changes.
Start-up sequence
Follow operating instructions
-
1 5
TransSteel Synergic
SP ... Special Program
- select desired parameter
- set desired parameter
Sheet thickness
Welding current
Wire feed speed
Arc length
correction
Welding voltage
Dynamic
- select desired parameter
- set desired parameter
To Next Page
Loading...
