Fronius TRANS STEEL 3500 C0MPACT - Connections, Switches and Mechanical Components; Front and Rear

34
Connections, switches and mechanical components
Front and rear
No. Function
(1) Welding torch connection
for connecting the welding torch
(2) (-) - Current socket with bayonet latch
used for
- connecting the grounding (earthing) cable during MIG/MAG welding
- connecting the electrode cable or grounding (earthing) cable during MMA welding
(depending on the type of electrode used)
(3) (+) - Current socket with bayonet latch
used for
- connecting the electrode cable or grounding (earthing) cable during MMA welding
(depending on the type of electrode used)
(4) LocalNet connection
Standardised connection socket for remote control
(5) Mains switch
for switching the power source on and off
(6) Mains cable with strain relief device
(7) "Feeder inching"/"Gas test" button
Push button downwards and hold:
for threading the wire electrode into the torch hosepack with no accompanying flow
of gas. While the button is being held down, the wire drive runs at wire threading
(1) (9) (8)
(2) (3) (4) (5) (7)(6)