65
g
If there is a "Feeder inching"/"Gas test" button:
- Press the "Feeder inching" / "Gas test" button upwards and release
- Turn the adjusting screw on the underside of the pressure regulator until the pres-
sure gauge shows the required gas flow rate
- Press the "Feeder inching" / "Gas test" button upwards again and release
If there is no "Feeder inching"/"Gas test" button:
- Press the "Mode" button to select 2-step mode
- Set the "Ito" parameter to "Off" in the set-up menu
- Disengage the feed rollers
- press and hold the torch trigger
- turn the adjusting screw on the underside of the pressure regulator until the pres-
sure gauge shows the required shielding gas flow rate
- release the torch trigger
- engage the feed rollers
Press the torch trigger and start welding
Corrections dur-
ing welding
To obtain the best possible welding results, the arc length correction and dynamic welding
parameters will sometimes need to be corrected.
Press the "Parameter selection" buttons to select the parameters you wish to correct.
Use the adjusting dials to set the selected welding parameters to the required values.
Welding parameter values are shown in the indicators located above them.
Arc length correction
for correcting the arc length
- shorter arc length
0 neutral arc length
+ longer arc length
Dynamic
for influencing the short-circuiting dynamic at the moment of droplet transfer
- harder, more stable arc
0 neutral arc
+ soft, low-spatter arc
CAUTION! Risk of injury and damage from electric shock and from the wire
electrode emerging from the torch. When pressing the torch trigger:
- keep the welding torch away from your face and body
- do not point the welding torch at people
- make sure that the wire electrode does not touch any electrically
conducting or earthed (grounded) parts, such as the housing, etc.
CAUTION! Risk of injury and damage from electric shock and from the wire
electrode emerging from the torch. When pressing the torch trigger:
- keep the welding torch away from your face and body
- do not point the welding torch at people
- make sure that the wire electrode does not touch any electrically
conducting or earthed (grounded) parts, such as the housing, etc.
10
To Next Page
Loading...
