Fronius TRANS STEEL 3500 C0MPACT - Corrections During Welding

To Next Page

To Previous Page

Set the shielding gas flow rate:

If there is a "Feeder inching"/"Gas test" button:

- Press the "Feeder inching" / "Gas test" button upwards and release

- Turn the adjusting screw on the underside of the pressure regulator until the pres-

sure gauge shows the required gas flow rate

- Press the "Feeder inching" / "Gas test" button upwards again and release

If there is no "Feeder inching"/"Gas test" button:

- Press the "Mode" button to select 4-step mode

- Set the "Ito" parameter to "Off" in the set-up menu

- Disengage the feed rollers

- press the torch trigger briefly

- turn the adjusting screw on the underside of the pressure regulator until the pres-

sure gauge shows the required shielding gas flow rate

- press the torch trigger again briefly

- engage the feed rollers

Press the torch trigger and start welding

Corrections dur-

ing welding

To obtain the best possible welding results, the dynamic welding parameter will sometimes

need to be adjusted.

Press the "Parameter selection" button to select the dynamic welding parameter

Use the adjusting dial to set the desired dynamic value

The welding parameter value is shown in the digital display located above it.

Dynamic

for influencing the short-circuiting dynamic at the moment of droplet transfer

0 harder, more stable arc

10 soft, low-spatter arc

CAUTION! Risk of injury and damage from electric shock and from the wire

electrode emerging from the torch. When pressing the torch trigger:

- keep the welding torch away from your face and body

- do not point the welding torch at people

- make sure that the wire electrode does not touch any electrically