78
Set-up parame-
ters for MIG/MAG
standard manual
welding
"Min." and "max." are used for setting ranges that differ according to power source, welding
program, etc.
GPr
Gas pre-flow time
Unit: s
Setting range: 0 - 9.9
Factory setting: 0.1
GPo
Gas post-flow time
Unit: s
Setting range: 0 - 9.9
Factory setting: 0.1
Fdi
Wire threading speed
Unit: m/min (ipm.)
Setting range: 1 - max. (39.37 - max.)
Factory setting: 10 (393.7)
bbc
Burn-back time correction
Unit: ms
Setting range: 0 - 20
Factory setting: 0
IGC
Ignition current
Unit: A
Setting range: 100 - 650
Factory setting: 500
Ito
Ignition time-out - length of wire that is fed before the safety cut-out trips
Unit: mm (in.)
Setting range: Off, 5 - 100 (Off, 0.2 - 3.94)
Factory setting: Off
FAC
Reset power source to factory setting
Press and hold down one of the "Parameter selection" buttons for 2 s to restore the
factory settings
NOTE! The "Ignition time-out" function (ito) is a safety function. The length of
wire that is fed before the safety cut-out trips may differ from the pre-set wire
length, particularly when the wire is being fed at fast wire feed speeds.
The "Ignition time-out" function (ito) is explained in the "Special functions and
options" section.
To Next Page
Loading...
