Fronius TRANS STEEL 3500 C0MPACT - Set-Up Parameters for MIG;MAG Standard Synergic Welding

80
Set-up parame-
ters for MIG/MAG
standard syner-
gic welding
"Min." and "max." are used for setting ranges that differ according to power source, welding
program, etc.
GPr
Gas pre-flow time
Unit: s
Setting range: 0 - 9.9
Factory setting: 0.1
GPo
Gas post-flow time
Unit: s
Setting range: 0 - 9.9
Factory setting: 0.1
SL
Slope
Unit: s
Setting range: 0 - 9.9
Factory setting: 0.1
I-S
I (current) - Starting - Starting current
Unit: % (of welding current)
Setting range: 0 - 200
Factory setting: 100
I-E
I (current) - End: final current
Unit: % (of welding current)
Setting range: 0 - 200
Factory setting: 50
t-S
t (time) - Starting - Starting current duration
Unit: s
Setting range: OFF, 0.1 - 9.9
Factory setting: OFF
t-E
t (time) - End - Final current duration
Unit: s
Setting range: OFF, 0.1 - 9.9
Factory setting: OFF
Fdi
Wire threading speed
Unit: m/min (ipm.)
Setting range: 1 - max. (39.37 - max.)
Factory setting: 10 (393.7)
bbc
Burn-back time correction -
Burn-back effect due to wire withdrawal at the end of welding
Unit: s
Setting range: Aut, 0 - 0.3