Fronius TRANS STEEL 3500 C0MPACT - Setup Menu - Level 2; Restrictions; Setting the Set-Up Parameters

83
g
Setup menu - Level 2
Restrictions In conjunction with the Level 2 set-up menu, the following restrictions occur:
The Level 2 set-up menu cannot be selected:
- during welding
- if the "Gas test" function is active
- if the "Wire threading" function is active
- if the "Wire withdrawal" function is active
- if the "Blow through" function is active
If the Level 2 set-up menu is selected, the following functions are not available, even in ro-
bot mode:
- Welding start-up - the "Power source ready" signal will not be emitted
-Gas testing
- Wire threading
- Wire withdrawal
- Blow-through
Setting the set-up
parameters
Opening the set-up menu
The control panel is now in the set-up menu - the last set-up parameter that was selected
is displayed.
Select "2nd" welding parameter
Accessing the Level 2 set-up menu
Changing welding parameters
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
use the "Mode" and "Process" buttons or the left adjustment dial
to select the set-up parameter "2nd"
1
2
3
4
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
select the required set-up parameter using the "Mode" and "Proc-
ess" buttons or the left adjusting dial
5
6
7
8