Fronius TransSteel 2200c - Page 2

Display service parameters
EasyJobs
Retrieve:
1x
Save:
Delete:
Activating/deactivating the key lock
Exiting the Setup menu
Available parameters: Example of display:
Firmware version
Welding program conguration
Current welding program
Arc time in hours
Motor current for wire drive in ampere
2nd menu level (Service)
MIG/MAG Synergic Setup menu
1. 2. 2.
Parameters:
Gas pre-ow time
Gas post-ow time
Slope (2-step, special 4-step)
Starting current (2-step, special 4-step)
Final current (2-step, special 4-step)
Starting current duration (2-step)
Final current duration (2-step)
Feeder inching speed
Burn-back eect
Length of wire that is fed before the safety cut-out
trips
Spot welding time / interval welding time
Interval pause time
Operating mode for stitch welding
Restore factory setup
Level 2 Setup menu
Country-specic setting
Welding circuit resistance
Welding circuit inductivity
Real Energy Input
Mains fuse protection
Arc length correction display
MIG/MAG Manual Setup menu
2.
1. 2.
Parameters:
Gas pre-ow time
Gas post-ow time
Feeder inching speed
Burn-back eect
Ignition current
Length of wire that is fed before the safety
cut-out trips
Spot welding time / interval welding time
Interval pause time
Operating mode for stitch welding
Restore factory setup
Level 2 Setup menu
Country-specic setting
Welding circuit resistance
Welding circuit inductivity
Real Energy Input
Mains fuse protection
MMA Setup menu
1. 2. 2.
Parameters:
HotStart current
HotStart time
Anti-stick
Restore factory setup
TIG Setup menu
2.2.1.
Parameters:
Pulse frequency
UpSlope
DownSlope
Starting current
Reduced current
Final current
Gas post-ow time
Tacking
Restore factory setup
Level 2 Setup menu
Country-specic setting
Mains fuse protection
Level 2 Setup menu
Country-specic setting
Welding circuit resistance
Welding circuit inductivity
Mains fuse protection