Fronius TransSteel 2200c - Parameters for MIG;MAG Standard Manual Welding; Parameters for MIG;MAG Welding

100
Parameters for MIG/MAG standard manual welding
Parameters for
MIG/MAG welding
SEt Country-specific setting (Standard/USA) Std/US
Unit: -
Setting range: Std, US (Standard/USA)
If Std is selected, the EURO welding programs are used as stated in the welding
program table.
If US is selected, the US welding programs are used as stated in the welding pro-
gram table.
Factory setting:
Standard version: Std (measurements: cm/mm)
USA version: US (measurements: inches)
FUS Mains fuse protection
The maximum possible welding power is limited by the rating of the mains fuse
protection.
Unit: A
The available mains fuse ratings are determined by the SEt parameter setting:
SEt parameter set as Std: OFF / 10 / 13 / 16
SEt parameter set as US: OFF / 15 / 20 (only for 120 V mains voltage)
Factory setting: OFF
r Welding circuit resistance (in mOhm)
See section "Measuring welding circuit resistance r"
L Welding circuit inductivity (in microhenrys)
See section "Displaying welding circuit inductivity L"
EnE Real Energy Input
Unit: kJ
Setting range: ON / OFF
Factory setting: OFF
Since the full range of values (1 kJ - 99999 kJ) cannot be displayed on the three-
digit display, the following display format has been selected:
Value in kJ: 1 to 999 / indicator on display: 1 to 999
Value in kJ: 1000 to 9999 / indicator on display: 1.00 to 9.99 (without unit digit,
e.g. 5270 kJ -> 5.27)
Value in kJ: 10000 to 99999 / indicator on display: 10.0 to 99.9
(without unit digit or tens digit, e.g. 23580 kJ -> 23.6)