Fronius TransSteel 2200c - Parameters for TIG Welding; Parameters for TIG Welding in the Setup Menu Level2

103
EN
Parameters for TIG welding
Parameters for
TIG welding in the
Setup menu
level 2
SEt Country-specific setting (Standard/USA) Std/US
Unit: -
Setting range: Std, US (Standard/USA)
Factory setting:
Standard version: Std (measurements: cm/mm)
USA version: US (measurements: inches)
FUS Mains fuse protection
The maximum possible welding power is limited by the rating of the mains fuse
protection.
Unit: A
The available mains fuse ratings are determined by the SEt parameter setting:
SEt parameter set as Std: OFF / 10 / 13 / 16
SEt parameter set as US: OFF / 15 / 20 (only for 120 V mains voltage)
Factory setting: OFF