25
EN
General
Device concept
The TransSteel (TSt) 2200c power source
is a completely digitised, microprocessor-
controlled power source.
This power source is designed for the wel-
ding of steel and can be used for the follo-
wing welding processes:
- MIG/MAG welding
- MMA welding
- TIG welding with touchdown ignition
The central control and regulation unit of the power source is coupled with a digital signal
processor. The central control and regulation unit and signal processor control the entire
welding process.
During the welding process, the actual data is measured continuously and the device re-
sponds immediately to any changes. Control algorithms ensure that the desired target
state is maintained.
"Power limita-
tion" function
The power source has a "Power limitation" safety feature.
This function is only available for the MIG/MAG standard synergic welding process.
Mode of operation:
If necessary, the power source reduces the welding power to prevent the arc from being
extinguished during welding at the power limit of the power source. The reduced parame-
ters are displayed on the control panel until welding starts again or until the next parameter
change.
This results in:
- A more precise welding process
- A high degree of reproducibility of all results
- Exceptional weld properties
As soon as the function is active, the indicator for the wire speed parameter on the
control panel flashes. The flashing continues until welding starts again or until the
next parameter change.
To Next Page
Loading...
