36
Keylock A keylock can be activated to prevent the settings from being inadvertently changed on the
control panel. As long as the keylock is active
- Settings cannot be adjusted on the control panel
- Parameter settings can be displayed
- It is possible to switch between EasyJobs if an EasyJob was selected before activating
the keylock
Activate/deactivate the keylock as follows:
No. Function
(12) "Material" button
For selecting the filler metal to be used
(13) "Save" button 1
For saving an EasyJob
(14) "Mode" button
For selecting the operating mode
2 T = 2-step mode
4 T = 4-step mode
S 4 T = Special 4-step mode
Spot welding/stitch welding
(15) "Wire diameter" button
For selecting the wire diameter to be used
(16) "Save" button 2
For saving an EasyJob
(17) "Process" button
For selecting the welding process
MANUAL = MIG/MAG standard manual welding
SYNERGIC = MIG/MAG standard synergic welding
STICK = Manual metal arc (MMA) welding
TIG = TIG welding
(18) "Shielding gas" button
For selecting the shielding gas to be used
(14)(13) (16)(15) (17)
(12)
(18)
Press and hold the "Mode" button
1
To Next Page
Loading...
