59
EN
5 6
Wire threading process (press the "Wire
threading" button on the control panel):
- Hold down the button for up to one se-
cond (briefly press the button): the
wire speed stays at 1 m/min (39.37
ipm) for the first second.
- Hold down the button for up to 2.5 se-
conds: after one second, the wire
speed increases over the next 1.5 se-
conds.
- Hold down the button for longer than
2.5 seconds: after 2.5 seconds, the
wire is fed at a constant rate equal to
the wire speed set for the Fdi welding
parameter.
Setting the con-
tact pressure
CAUTION! Risk of injury from emerging wire electrode. When pressing the "Wire
threading" button/the torch trigger:
- Keep the welding torch away from your face and body
- Wear suitable protective goggles
- Do not point the welding torch at people
- Make sure that the wire electrode does not touch any conductive or earthed
parts (e.g. housing)
5 6
Fdi
1
234
5
2,51
t (s)
(m/min, ipm)
NOTE! Set the contact pressure according to the table below, so that the wire
electrode is not deformed and proper wirefeeding is ensured.
To Next Page
Loading...
