Fronius TransSteel 2200c - Parameters for MMA Welding; Setup Parameters for MMA Welding

95
EN
Parameters for MMA welding
Setup parameters
for MMA welding
HCU HotStart current
Unit: %
Setting range: 100 - 200
Factory setting: 150
Hti Hot current time
Unit: Seconds
Setting range: 0 - 2.0
Factory setting: 0.5
Ast Anti-stick function
Unit: -
Setting range: On, OFF
Factory setting: OFF
FAC Reset power source to factory settings
Press and hold one of the "Parameter selection" buttons for two seconds to restore
the factory settings
- when "PrG" appears on the digital display, the power source has been reset.
2nd Second level of the Setup menu (see "Setup menu - level 2")
NOTE! If the power source is reset, the majority of the applied settings are
deleted. The following values remain:
- Welding circuit resistance and welding circuit inductivity
- Country-specific setting