Fronius TransSteel 2500c - Page 88

88
Changing welding parameters
Exiting the Level 2 Setup menu
Exiting the Setup menu
Use the "Mode" and "Process" buttons or the left-hand adjusting
dial to select the required setup parameter
8
Change the value of the setup parameter using the "Parameter
selection" buttons or the right-hand adjusting dial
9
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
10
11
12
13
14
15