Before installation and commissioning
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
▶
Read and understand this document in full.
▶
Read and understand all safety rules and user documentation for this device
and all system components.
WARNING!
Danger from electrical current.
This can result in serious personal injury and damage to property.
▶
Before starting work, switch off all devices and components involved and dis-
connect them from the grid.
▶
Secure all devices and components involved so they cannot be switched back
on.
▶
After opening the device, use a suitable measuring instrument to check that
electrically charged components (such as capacitors) have been discharged.
Utilisation for in-
tended purpose
only
The power source may only be used for MIG/MAG and MMA welding.
Any other form of usage is deemed "not in accordance with the intended pur-
pose".
The manufacturer shall not be held liable for any damages arising from such us-
age.
Utilisation in accordance with the "intended purpose" also comprises
-
following all the information in the operating instructions
-
carrying out all the specified inspection and servicing work
Setup regula-
tions
The device is tested to IP 23 protection, meaning:
-
Protection against penetration by solid foreign bodies with diameters > 12
mm (0.49 in.)
-
Protection against spraywater at any angle up to 60° to the vertical
The device can be set up and operated outdoors in accordance with degree of
protection IP 23.
Avoid direct wetting (e.g. from rain).
WARNING!
Danger from machines toppling over or falling.
This can result in serious personal injury and damage to property.
▶
Set up the device securely on an even, solid surface.
▶
Check all screw connections are tightly fastened after installation.
42
To Next Page
Loading...
