Fronius TransSteel 5000 Syn - Fitting the Interconnecting Hosepack Strain-Relief Device; Connecting the Interconnecting Hosepack

Fitting the inter-
connecting
hosepack strain-
relief device
1
2
3
4
Fitting the strain-relief device to the trolley
1
2
1
3
4
Fitting the strain-relief device to the wirefeeder
2
IMPORTANT! To prevent wear and tear, leave some slack when connecting the
cables. A strain-relief device is not provided for 1.2 m (3 ft 11.24 in.) intercon-
necting hosepacks.
Connecting the
interconnecting
hosepack
WARNING!
Fitting the equipment incorrectly can cause serious injury and damage.
▶
Do not carry out the steps described here until you have read and completely
understood all the Operating Instructions.
NOTE!
When connecting the interconnecting hosepack, check that
▶
all connections are connected properly
▶
all cables, leads and hosepacks are undamaged and correctly insulated
IMPORTANT! There is no cooling unit present in the case of gas-cooled systems.
There is no need to attach the water connections in the case of gas-cooled sys-
tems.
1
1
2
7
4
5
6
3
2
51
EN