CAUTION!
Risk of injury and damage from electric shock and from the wire electrode
emerging from the torch.
When pressing the torch trigger
▶
keep the welding torch away from your face and body
▶
wear suitable protective goggles
▶
do not point the welding torch at people
▶
make sure that the wire electrode does not touch any conductive or earthed
parts (e.g. housing)
10
Press the torch trigger and start welding
Corrections dur-
ing welding
The arc length correction and arc-force dynamic parameters can be used to op-
timise the welding result.
Arc length correction:
- = shorter arc, reduced welding voltage
0 = neutral arc
+ = longer arc, increased welding voltage
Arc-force dynamic:
To influence the short-circuiting dynamic at the instant of droplet transfer
- = hard, stable arc
0 = neutral arc
+ = soft, low-spatter arc
70
To Next Page
Loading...
