Process Welding process
Mode Operating mode
Status PASS: regular welding
IGN: Welding interrupted during the ignition phase
Err | xxx: Welding interrupted due to a fault; the corresponding ser-
vice code is documented
Interval Weld seam number for "Interval" operating mode
Signa-
ture
Signature per weld seam number
* In each case from the main process phase;
In the event of termination in the ignition phase, the average value
in the ignition phase is stored and a identifier is output to indicate
that the main process phase has been reached
The welding data is documented as average values in the main process phase and
per weld.
New CSV file A new CSV file is generated:
-
if the USB flash drive is disconnected and reconnected while the power
source is on
-
If the date and time are changed
-
From 1000 welds
-
During a firmware update
-
if the USB flash drive is disconnected and reconnected to another power
source
(= change of serial number).
PDF report /
Fronius signa-
ture
By scanning the link on the left
-
A PDF report of the selected welding data can be created
-
The authenticity of the data can be checked and guaran-
teed via the Fronius signature read out with the welding
data.
https://easydocu.weldcube.com
88
To Next Page
Loading...
