Fronius TransSteel 5000 Syn - Easy Documentation Activation;Deactivation

Activating / deactivating Easy Documentation
Setting the date
and time
The date and time are set in the 2nd level of the service menu.
+
1
The first parameter in the service
menu is displayed.
...
2
Select the "2nd" setup parameter us-
ing the left-hand adjusting dial
+
3
The first parameter in the 2nd level of
the service menu is displayed.
...
4
Select the "yEA" (= year) setup para-
meter using the left-hand adjusting
dial
5
To set the date and time:
-
Left-hand adjusting dial:
Select parameter
-
Right-hand adjusting dial:
Change values
Setting ranges:
yEA Year (20yy; 0 - 99)
Mon Month (mm; 1 -1 12)
dAY Day (dd; 1 - 31)
Hou Hour (hh; 0 - 24)
Min Minute (mm; 0 - 59)
NOTE!
If the power source is reset to factory settings via setup parameter FAC, the
date and time remain stored.
Deactivating
Easy Document-
ation
CAUTION!
Risk of data loss or data damage due to premature disconnection of the USB
flash drive
▶
Do not disconnect the USB flash drive until approx. 10 seconds after the end
of the last weld to ensure correct data transfer.
89
EN