Frontier LS2015 - Boom Section Control and Spray Nozzle Use

5CS201115OM (rev 00 07/2020) 23
9. Engage PTO, and make sure pressure
setting is correct. While spraying, maintain
a constant level of speed and rpm (rates
determined when calibrated).
10. When complete, fold boom back into
transport position. On 24 ft and 30 ft boom
ensure the retaining strap is in place.
Boom Section Control
The Boom is divided into 3 sections of spray
tips. Right, Center and Left. Each section can
be turned ON and OFF individually using the
boom section control valves.
1. To turn a section ON move the
corresponding handle to the horizontal
position.
2. To turn a section OFF move the handle to
the down position.
• Right Section (A), Center Section(B), Left
Section (C)
Spraying with the Spray Nozzle
CAUTION: Avoid Injury! DO NOT use
spray nozzle while tractor is in motion.
1. Turn all Section Control valves to OFF.
2. Squeeze the handle (A) to spray.
3. Adjust mist to stream using lever (B).
4. Spray guard (C) can be adjusted by
loosening (D) and sliding spray guard
to desired position. The spray guard is
intended to keep over-spray off your hands.
5. Flip handle lock (E) forward to lock handle in
ON position.
C
D
B
A
E
A B C
Operation