Frontier LS2015 - Filter Maintenance and Dealer Support

5CS201115OM (rev 00 07/2020) 25Service
NOTE: Verify that the opening (E) in the spray
tip is pointing down when the nozzle assembly
is installed on the nozzle socket.
6. Install the screen (D) into the nozzle socket
on the boom.
7. Install nozzle assembly on the nozzle
socket.
NOTE: Due to normal wear, Teejet®
recommends replacing sprayer nozzles after
every spraying season. Nozzle replacement will
ensure accurate spraying performance.
Cleaning and Replacing Filter
CAUTION: Chemicals can be
dangerous. Avoid injury to operator
or bystanders.
• Wear protective clothes, gloves and
goggles when handling sprayer.
• Do not put the nozzle tips or other parts to
your lips to blow out dirt.
• If spray comes in contact with your body,
immediately follow directions on chemical
container pertaining to spray material.
NOTICE: Spray material captured in hoses
may leak out when lter is removed. Clean
the area immediately after servicing.
1. Turn all Section Control valves to OFF.
2. Turn 3-way valve (A) to OFF Position
(vertical).
3. Unscrew lter Housing (B) and remove lter.
4. To clean lter ush with clean water and
reinstall lter. Ensure lter housing is tight.
5. Turn 3-way valve (A) to ON Position
(towards lter) and check for leaks around
lter housing.
Quality Service
Frontier Quality Continues with Quality
Service
Frontier provides a process to handle your
questions or problems, should they arise, to
ensure that product quality continues with your
Frontier dealer’s parts and service support.
Follow the steps below to get answers to any
questions you may have about your product.
1. Refer to the appropriate attachment,
machine or equipment operator’s manuals.
2. Contact your Frontier dealer with
unanswered questions.
B
A
A
B
E
D
C
F