Menu Tree
Quick select options
Long press the Encoder Button there will generate a pop-up where the user can reset timer, reset
telemetry values, reset all above, jump to the tele setup page.
Model Setup for Taranis Q X7/X7S ACCESS Internal RF Module
Step 1: Set the Mode for Taranis Q X7/X7S ACCESS Internal RF.
Go to the MODEL SETUP menu, and select the Internal RF, select [Mode] [ACCESS].
Step 2: Set the Channel Range
The Internal RF module of Taranis Q X7/X7S ACCESS supports up to 24 channels. The channel range is
configurable, and needs to be confirmed before use.
Step 3: Set the Receiver Number
When you create a new model, the system will assign you a receiver number automatically, but this
can be easily changed. The range of the receiver number is 00-63, with the default number being 01
(use 00 is not recommended). Once the receiver is set to desired number and is bound to the Taranis
Q X7/X7S ACCESS, the bind procedure will not need to be repeated unless the receiver number is
changed. In this case, either set the receiver number to the previous one or repeat the bind procedure.
To Next Page
Loading...
