FLYING SAFETY
Warning:
To ensure the safety of yourself and others, please observe the following precautions. Have regular
maintenance performed. Although your Taranis Q X7/X7S ACCESS protects the model memories with
non-volatile EEPROM memory (which does not require periodic replacement) and of a battery, it still
should have regular check-ups for wear and tear. We recommend sending your system to your FrSky
Service Center annually during your non-flying-season for a complete check-up and service.
Battery
Using a fully charged battery (DC 6.5~8.4V). A low battery will soon die, causing loss of control and a
crash. When you begin your flying session, reset your transmitter’s built-in timer, and during the
session pay attention to the duration of usage. Also, if your model used a separate receiver battery,
make sure it is fully charged before each flying session. Stop flying long before your batteries become
over discharged. Do not rely on your radio’s low battery warning systems, intended only as a
precaution, to tell you when to recharge. Always check your transmitter and receiver batteries prior to
each flight.
Where to Fly
We recommend that you fly at a recognized model airplane flying field. You can find model clubs and
fields by asking your nearest hobby dealer. Always pay particular attention to the flying field’s rules,
as well as the presence and location of spectators, the wind direction, and any obstacles on the field.
Be very careful flying in areas near power lines, tall buildings, or communication facilities as there may
be radio interference in their vicinity.
At the flying field
To prevent possible damage to your radio gear, turn the power switches on and off in the proper
sequence:
1. Pull throttle stick to idle position, or otherwise disarm your motor/engine.
2. Turn on the transmitter power and allow your transmitter to reach its home screen.
3. Confirm the proper model memory has been selected.
4. Turn on your receiver power.
5. Test all controls. If a servo operates abnormally, don’t attempt to fly until you determine the
cause of the problem.
6. Start your engine.
7. Complete a full range check.
8. After flying, bring the throttle stick to idle position, engage any kill switches or otherwise disarm
your motor/engine.
Updates
FrSky is continuously adding features and improvements to our radio systems. Updating (via USB Port
or the Micro SD card) is easy and free. To get the most from your new transmitter, please check the
download section of the FrSky website for the latest update firmware and guide for adjusting your
sticks. (www.frsky-rc.com)
FrSky Electronic Co., Ltd. www.frsky-rc.com
Contact us: frsky@frsky-rc.com
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China
Technical Support: sales4tech@gmail.com
FrSky 2.4GHz Taranis Q X7/ X7S Access Manual – Download [optimized]
FrSky 2.4GHz Taranis Q X7/ X7S Access Manual – Download
To Next Page
Loading...
