M02 without Clock Page 2 of 8
1) Scoreboard connections:
The scoreboard should be supplied with a 230V mains supply.
The mains supply should be fed through a 5 amp circuit breaker
and it is highly recommended that the supply should be fed through
a Residual Current Device (RCD)
If the scoreboard has been supplied with a separate aerial this
should be mounted as high as possible
2) On Power Up:
'Cd - ' will be displayed for 5 seconds
o This is a "code" number stored in memory
o There are 5 possible codes that may be used, this
allows a number of displays to be operated in close
proximity of each other
o Further details on programming the code can be
found at the end of the manual
The scoreboard will now go into normal operation, displaying
scores with the clock blanked.
To Next Page
Loading...