Fuji Electric ALPHA5 Smart - Battery Warning: Sequence Output Signal (Reference Value 45); Forced Stop Detection: Sequence Output Signal (Reference Value 41); Home Position LS Detection: Sequence Output Signal (Reference Value 40)

CHAPTER 2 WIRING
Description of I/O Signals 2-79
2
Home position LS detection: Sequence output signal (Reference value 40)
The signal is output while the home position LS signal (input signal) remains turned on.
 Function
The sequence output corresponding to home position LS detection is turned on while the home
position LS sequence input signal remains turned on.
 Parameter setting
To assign home position LS detection to a sequence output terminal, specify the corresponding
value ("40") to the output terminal function setting parameter.
Forced stop detection: Sequence output signal (Reference value 41)
The signal is turned on while the forced stop signal (input signal) remains turned on (relay:open).
 Function
Forced stop detection is turned on when the forced stop sequence input signal is turned on
(relay:open). For details, refer to "Forced stop."
 Parameter setting
To assign forced stop detection to a sequence output terminal, specify the corresponding value
("41") to the output terminal function setting parameter.
Battery warning: Sequence output signal (Reference value 45)
The signal is output if the battery voltage is smaller than the rated value.
 Function
If the battery voltage is smaller than the rated value in an established ABS system (absolute
system), a battery warning signal is turned on.
 Parameter setting
To assign battery warning to a sequence output terminal, specify the corresponding value ("45") to
the output terminal function setting parameter.
Replace the battery immediately if this signal is turned on.