xiii
5.8.2 Parameters Used for Short cycle time Operation Mode··············· 5-23
5.8.3 Adjustment Procedure in Short cycle time Operation Mode ········· 5-24
5.9 Profile Operation ··································································· 5-25
5.9.1 What is Profile Operation?···················································· 5-25
5.9.2 Description of Operation ······················································ 5-26
5.10 Special Adjustment (Vibration Suppression) ··························· 5-28
5.10.1 What is Vibration Suppression ? ·········································· 5-28
5.10.2 Automatic Vibration Suppression ········································· 5-30
5.10.3 Manual Adjustment of Vibration Suppression ·························· 5-31
CHAPTER 6 KEYPAD
6.1 Display···················································································6-2
6.1.1 Mode ·················································································6-2
6.1.2 Key ···················································································6-3
6.1.3 Blinking Display ···································································6-3
6.1.4 Displaying Upper/middle/lower Data ·········································6-3
6.1.5 Mode Selection ····································································6-4
6.2 Function List···········································································6-5
6.3 Sequence Mode·······································································6-9
6.4 Monitor Mode········································································ 6-13
6.5 Station Number Mode····························································· 6-27
6.6 Maintenance Mode································································· 6-28
6.7 Parameter Edit Mode······························································ 6-33
6.8 Positioning Data Edit Mode····················································· 6-39
6.9 Test Operation Mode······························································ 6-43
CHAPTER 7
MAINTENANCE AND INSPECTION
7.1 Inspection ··············································································7-2
7.2 Status Display·········································································7-3
7.2.1 Initial State··········································································7-3
7.2.2 State at Alarm······································································7-3
7.2.3 Alarm Display List·································································7-4
7.3 Troubleshooting Method ··························································7-6
7.4 Items to be Inquired upon Trouble ··········································· 7-16
7.5 Maintenance and Discarding ··················································· 7-17
7.5.1 Operating Environment························································ 7-17
7.5.2 Life·················································································· 7-18
7.5.3 Discarding ········································································ 7-18
7.6 Approximate Replacement Timing ··········································· 7-19
7.7 Troubleshooting ···································································· 7-20
To Next Page
Loading...