Fuji Electric ALPHA5 Smart - 6.5 Station Number Mode

CHAPTER 6 KEYPAD
Station Number Mode 6-27
6
6.5 Station Number Mode
In the station number mode, the station number of the servo amplifier is displayed and a new station
number can be entered.
Press the [MODE/ESC] key until [
An01] is displayed, and press and hold the [SET/SHIFT] key for at
least one second to display data.
An01: Station number
031
-
031
An01
SET (1 sec. or over)
031
SET (1 sec. or over)
031
SHIFT
031
030
SHIFT
∧／∨
030
SET (1 sec. or over)
ESC
ESC
ESC
ESC
ESC
ESC
Communication time over
Displays the station number currently set in the
parameter.
Entering the edit mode, the third digit blinks.
The second digit blinks by pressing the SHIFT
key.
The first digit blinks by pressing the SHIFT key.
By pressing the [] and [] keys the value at
blinking digit is increased or decreased.
When the change is executed, all the digits
blinks three times.
Turn the power off and on again to enable the new station number.