Fuji Electric ALPHA5 Smart - 6.6 Maintenance Mode

CHAPTER 6 KEYPAD
6-28
Maintenance Mode
6
6.6 Maintenance Mode
In the maintenance mode, detected alarms, total time - main power supply and so on are displayed.
Press the [MODE/ESC] key until [
En01] is displayed and press and hold the [SET/SHIFT] key for at
least one second to display data.
: Alarm at present
: Alarm history
: Warning at present
: Total time - main power supply
: Motor running time
(1) Alarm at present
The alarm detected currently is displayed in a code.
 If the alarm reset is executed, the display will automatically return to the initial one.
After an alarm is detected, the following is displayed automatically. Supplementary data to the
alarm can be displayed, too.
En01
En02
En03
En04
En06
E
n01
oL1
ESC
rc01
SET (1 sec. or over)
rc02
rc03
rc04
rc06
rc07
r
c08
r
c09
r
c10
r
c11
r
c12
r
c13
(Total time-main power
supply)
Unused
(Motor running time)
(Feedback speed)
(Command speed)
(Command torque)
(Motor current)
(Effective torque)
(DC link voltage)
(EC error count)
(Command position)
(Sequence mode)
9999
SET (1 sec. or over)
∧／∨
ESC
SET (1 sec. or over)
rc05
(Feedback speed before
five min)
∧／∨