CHAPTER 6 KEYPAD
6-36
Parameter Edit Mode
6
Settling the value
Press and hold the [SET/SHIFT] key for at least one second to settle the value. All digits blink
simultaneously. The settled value remains. (The value blinks at about 0.5-second intervals when it
is settled.)
Press the [MODE/ESC] key to return to the parameter number selection screen.
Value out of range
Values out of the allowable setting range can be entered as far as the number of digits allows.
[Example] In case of parameter PA1_7, you can enter in the range from 0 to 9999999 (setting
range: 1 to 4194304). However, the value out of the permissible setting range is not
reflected on the parameter (NG indication is caused).
Blinking display
When parameters which become enabled after the power is cycled once, the keypad display
blinks.
To Next Page
Loading...