Fuji Electric ALPHA5 Smart - Page 52

CHAPTER 2 WIRING
2-4
Configuration
2
 Servo amplifier (frame3)
 Servo amplifier (frame4)
L1 L2 L3 P(+) N(-)
RB1 RB2 RB3 U V W
Sequence I/O (CN1)
Encoder wiring (CN2)
Battery wiring (CN5)
Battery and the case
(option)
Main circuit
(TB2)
- P-N junction
- Regenerative
resistor
Power supply
(TB1)
- Main power
Analog monitor (CN4)
The analog waveform is monitored.
Motor power
(TB3)
RS-485 (CN3A (IN), CN3B (OUT))
Upper side: CN3A, lower side: CN3B
Charge LED
L1
L2
L3
P(+)
RB1
RB2
RB3
N(-)
U
V
W
Keypad
4-digit 7-segment LED, 4 buttons and monitor
terminals are installed.
Grounding terminal (2 pcs)
(Screw size : M4)
TB2(Screw size : M4)
Grounding terminal
(Screw size : M4)
Grounding terminal
(Screw size : M4)
TB1(Screw size : M4)
Analog monitor (CN4)
The analog waveform is monitored.
Keypad
4-digit 7-segment LED, 4 buttons and monitor
terminals are installed.
RS-485 (CN3A (IN), CN3B (OUT))
Upper side: CN3A, lower side: CN3B
Sequence I/O (CN1)
Encoder wiring (CN2)
Battery wiring (CN5)
Charge LED
Battery and the case
(option)