CHAPTER 2 WIRING
2-8
Configuration
2
2) Connecting to peripheral devices (Servo amplifier frames 2, 3 and 4)
For the motors with the Cannon connector, connect cables as shown below.
molex
MCCB/ELCB
Servo amplifier
Servomotor
Encoder cable
AC reactor
Power filter
Motor power cable
(Should be fabricated by the customer.)
Electromagnetic
contactor
External regenerative resistor
(Disconnect the jumper wire and
connect across pins 2 and 3.)
RS-485
communications
(L1, L2, L3)
Grounding
terminal
To Next Page
Loading...