2-13
2-3 Names and Functions
9) Power supply terminal block (display unit)
Supplies the power to the display unit (24 V DC).
10) Modular jack 1 (MJ1)
Used for screen data transfer and connection with PLCs or other peripheral devices.
11) Modular jack 2 (MJ2)
Used for connection with PLCs or other peripheral devices.
12) PLC communication connector (CN1)
Used for connection with a controller (PLC, temperature controller, inverter, etc.).
13) 100BASE-TX/10BASE-T connector (LAN)
Used for Ethernet connection.
14) USB-B (slave port)
Used for screen data transfer or connection with a PictBridge-compatible printer.
15) USB-A (master port)
This is the connector where a printer or a CF card reader/writer is connected.
16) USB cable clamp mounting hole
For NP5M0101-5H4/4H4, NP5N0011-5H4/4H4, this hole is used for attaching a USB cable clamp.
For NP5M0101-3H4/NP5N0011-3H4, this hole is used for attaching a USB cable binder.
17) Mounting holes
Used for inserting fixtures when securing the @E.Terminal to the mounting panel.
To Next Page
Loading...
