5.3 Description of Function Codes
5-174
H49
Starting mode (Auto search delay time 1) (refer to H09)
For details, refer to the description of H09.
H50, H51
H52, H53
Non-linear V/f 1 (Frequency and voltage) (refer to F04)
Non-linear V/f 2 (Frequency and voltage)
For details, refer to the description of F04.
H54, H55
H56
H57 to H60
Acceleration/Deceleration time (Jogging) (refer to F07)
Deceleration time for forced stop
1st/2nd S-curve acceleration/deceleration range
For details, refer to the description of F07.
H61
UP/DOWN control (Initial frequency setting) (refer to F01)
For details, refer to the description of F01.
H63
Low limiter (Mode selection) (refer to F15)
For details, refer to the description of F15.
H64
Low limiter (Lower limiting frequency)
H64 specifies the lower limit of frequency to be applied when the current limiter, torque limiter, or overload
prevention control is activated. Normally, it is not necessary to change this data.
• Data setting range: 0.0 to 60.0 (Hz)
H65, H66
Non-linear V/f 3 (Frequency and voltage) (refer to F04)
For details, refer to the description of F04.
H68
Slip compensation 1 (Operating conditions) (refer to F42)
For details, refer to the description of F42.
To Next Page
Loading...
