Fuji Electric FRENIC-Ace series - Page 421

5.3 Description of Function Codes
5-251
FUNCTION CODES
Chap 5
The function code settings for each step are as follows:
• Step 1 to 14
Step No. Block selection Input 1 Input 2 Function 1 Function 2 Output
Note)
Step 1 U01 U02 U03 U04 U05 “SO01”
= 1 to 1999 Digital input 1 Digital input 2 Time setting Not required Digital output
= 2001 to 3999 Analog input 1
Analog input 2
Value 1 Value 2 Analog/digital
output
= 4001 to 6999 Analog input 1
Digital input 2 Value 1 Value 2 Analog output
Step 2 U06 U07 U08 U09 U10 “SO02”
Step 3 U11 U12 U13 U14 U15 “SO03”
Step 4 U16 U17 U18 U19 U20 “SO04”
Step 5 U21 U22 U23 U24 U25 “SO05”
Step 6 U26 U27 U28 U29 U30 “SO06”
Step 7 U31 U32 U33 U34 U35 “SO07”
Step 8 U36 U37 U38 U39 U40 “SO08”
Step 9 U41 U42 U43 U44 U45 “SO09”
Step 10 U46 U47 U48 U49 U50 “SO10”
Step 11 U51 U52 U53 U54 U55` “SO11”
Step 12 U56 U57 U58 U59 U60 “SO12”
Step 13 U61 U62 U63 U64 U65 “SO13”
Step 14 U66 U67 U68 U69 U70 “SO14”
Note) Output is not a function code. It indicates the output signal symbol.
• Step 15 to 200
Specify a step number in U190, and set the block selection, input 1, input 2, function 1, function 2 in U191 to U195
respectively.
Step No. U190
Block
selection
Input 1 Input 2 Function 1 Function 2 Output
Step 15
15
U191 U192 U193 U194 U195
“SO15”
Step 16
16
“SO16”
･･･ ･･･ ･･･
Step 199
199
“SO199”
Step 200
200
“SO200”