9.3.2 Connection
By connecting a number of inverters to one PC, you can control one inverter at a time or a number of inverters
simultaneously. You can also simultaneously monitor a number of inverters on the multi monitor.
For information how to connect a PC to one or more inverters, refer to the RS-485 Communication User’s
Manual (MEH448).
9.3.3 Function overview
[ 1 ] Configuring inverter’s function code
You can set, edit, and check the setting of the inverter’s function code data.
List and Edit
In List and edit, you can list and edit function codes with function code No., name, set value, set range, and factory
default.
You can also list function codes by any of the following groups according to your needs:
• Function code group
• Function codes that have been modified from their factory defaults
• Result of comparison with the settings of the inverter
• Result of search by function code name
• User-specified function code set
etc.
Comparison
You can compare the function code data currently being edited with that saved in a file or stored in the inverter.
To perform a comparison and review the result displayed, click the Comparison tab and then click the Compared
with inverter tab or click the Compared with file tab, and specify the file name.
The result of the comparison will be displayed also in the Comparison Result column of the list.
To Next Page
Loading...
