Fuji Electric FRENIC MEGA G2 Series - Page 332

5.3 Description of Function Codes 5.3.2 E codes (Extension terminal functions)
5-148
Table 5.3-6
Terminal command assigned
Operation (when switching from commercial power
supply to inverter startup)
Switch to commercial power sequence (50 Hz) “ISW50”
Startup at 50 Hz
Switch to commercial power sequence (60 Hz) “ISW60”
Startup at 60 Hz
Do not set both “ISW50” and “ISW60”. Operation will not be guaranteed if both are set.
<Circuit diagram and configuration>
Fig. 5.3-7
Table 5.3-7 Operation input/output related table
Input
Output (magnetic contactors)
Inverter
operation
“ISW50” / “ISW60”
Run
command
“SW52-1”
“SW52-2”
“SW88”
OFF (commercial power
supply)
ON
OFF
OFF
ON
OFF
OFF
OFF
ON (inverter)
ON
ON
ON
OFF
ON
OFF
OFF