12 Compliance with standards 12-2
FVR-C11S-EN
12
12-2 Compliance with EMC
directive in EU [Applicable to
products with CE mark]
12-2-1 General
The CE mark indicated on the FVR-C11S series
concerns with European minister directorate di-
rective 89/336/EEC concernin
the environmen-
tal electroma
netic compatibilit
EMC, and other
directives are not included.
The CE mark does not prove that the entire ma-
chine or s
stem housin
our product complies
with the EMC directive. Therefore indication of
the CE mark to the entire machine or s
stem will
be done at the responsibilit
of the manufacturer
or the machine. This is because:
1. The CE mark attached on our product sup-
poses operation of the product under certain
conditions. Satisfaction of the conditions is up
to the manufacturer of the machine.
2. Generall
speakin
, various devices are used
in a machine or s
stem as well as our prod-
uct. Therefore consideration for the entire
machine or s
stem must be paid b
the man-
ufacturer of the machine.
The EMC directive includes immunit
to the in-
comin
noise and emission of out
oin
noise.
The
eneral purpose inverter houses an internal
element switchin
at a hi
h speed which
ener-
ates electric noise.
Applicable standards
Immunit
: EN 61800-3
Emission: EN 61800-3
Above-mentioned "certain conditions" include
installation of a dedicated RFI filter in a metallic
control panel.
Refer to in exclusive Instruction Manual for RFI
Filter for details.
12-3 Compliance with low volta
e
directive in EU [Applicable to
products with T
V or CE
mark]
12-3-1 General
The
eneral purpose inverter is applicable for
the low volta
e directive in EU. Compliance of
the FVR-C11S series with EN 50178/1997 has
been obtained from a testin
or
anization in EU
and compliance with the low volta
e directive is
asserted.
12-3-2 Precautions
Refer to "Compliance with low volta
e directive
in EU" on pa
es 2 and 3 when usin
our product
as one compl
in
with the low volta
e directive
in EU.
To Next Page
Loading...
