Fuji Electric MICREX-SX series SPF - System Definition

2-7
Section 2 System Conguration
2-2 System denition
When using SPF series, you need to register the actual unit conguration in a project.
<Example of system conguration>
X20X22
X21X23
X0 X2 X4 X6 X8 X10X12 X14X16 X18
X1 X3 X5 X7 X9 X11 X13X15 X17 X19
m
a
x
.
400mA
24V OUT
S/S
PORT0
IN AC100~240V
Y1 Y2 Y4 Y5 Y6 Y8 Y10
C0 Y0 C2 Y3 C4 C6 Y7 C8 Y9 Y11
L N
N
A
0
P
A
4
0
T
-
3
1
C
Y14Y12
C12Y13 Y15
NA0E16T-0
Y1
Y2
C2 C4C0
Y0
Y5 Y7
Y3 Y4 Y6
Y10Y8 Y11 Y12 Y14
Y9C8 C10 C12 Y13 Y15
O0+O1+
AG O0-
NA0AW06-MR
O1-
24V IN
I0+I1+ I2+I3+
I0-I1- I2-I3-
PWR/
BAT
RUN/
MEM
ALM
IN (X)
OUT (Y)
NA0LA-RS5
TX
RX
TX
RX
PORT4 (RS485)
G
PORT3 (RS485)
T
+
T
N
N
+
G
Main unit
Type: NA0PA40T-31C
Expansion left side unit
Type: NA0LA-RS5
Front board
Type: NA3LA-RS1
Expansion right side unit
Type: NA0E16T-0
Expansion right side unit
Type: NA0AX06-MR
<System conguration denition tree window>
The system conguration denition tree for the above system conguration is shown below.
<Rules for dening system conguration>
• For system denition, the unit on the right of the main unit is registered just below the main unit.
As for the unit station Nos. of units, the main unit is always assigned “0” (zero), and numbers beginning with 1 (one) are
assigned to expansion right side units, in their connected order.
• The front board is connected on the front of the main unit and registered below the expansion right side unit in the conguration
denition tree. The unit station No. is xed to “100.”
• The expansion left side unit is connected to the left of the main unit and registered at the lowermost location in the conguration
denition tree. The unit station No. is xed to “200.”