3-41
Section 3 Specications
5) Memory pack connector
A memory pack for user ROM operation and data storage is connected.
• Memory pack (Type: NA8PMF-20)
Protect switch
(Right side face when mounted)
ON (upper side): Write protected
OFF (lower side): Write enabled
Item Protect switch OFF Protect switch ON
When the main unit is powered on
Operation is performed with the
project in the built-in ash memory
Operation is performed with the
project in the memory pack
Execution of project downloading
The project is also stored in the
memory pack.
Not possible
(CPU memory access error)
Execution of resource initialization
The project in the memory pack is
also cleared.
Not possible
(Clearing failed.)
Data writing to the memory pack Data can be written. Data can be written.
• Operation when a memory pack is mounted
• How to perform operation with a project in the memory pack (user ROM operation)
1) Power off the main unit.
2) Turn off the protect switch of the memory pack and mount it on the main unit.
3) Power on the main unit and download a project from the loader.
4) Power off the main unit.
5) Remove the memory pack from the main unit, turn on the protect switch, and then mount it on the main unit again.
6) Power on the main unit.
(Operation starts with the project in the memory pack.)
To Next Page
Loading...
